Broadcast Tools SS 2.1/Terminal III Specifikace stáhnout pdf (Strana 21)

e-mail:

voice:

360.854.9559

fax:

866.783.1742

Site Sentinel

16 Installation and Operation Manual

SETUP

Status

Input Status Messages: Used to identify the status input source.

Alarms OFF: This option enables the sending of an email when the

input is OFF.

Alarms ON: This option enables the sending of an email when the

input is ON.

Email Addresses: This allows you to configure up to 8 emails to be sent

whenever the input is turned ON or OFF.

Normal Signal Level: This drop-down configures the input signal to be normal-

ly High or normally Low. This is used to determine if an

input is ON or OFF.

NOTE: When the "Normal signal level" is set to HIGH = NO voltage is

applied to the input (WET or no closure when configured for DRY), it's con-

sidered OFF, when voltage IS applied (WET or completed closure set to DRY)

to the input, it considered ON.

Log Device: This enables the email logging of this device.

Delay time: The delay is in (0 to 999) seconds. This option specifies the wait

time from when a value is out of range before an alarm is acti-

vated.

Alarm LED: User defined color of LED on the Monitor and

Control page when in an alarm condition.

NOTE: After any item has been changed, you MUST press the “Save Settings”

button for your changes to be saved.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 41 42

Žádné komentáře

Broadcast Tools SS 2.1/Terminal III Specifikace Strana 21