Broadcast Tools SS 2.1/Terminal III Uživatelský manuál Strana 64
- Strana / 188
- Tabulka s obsahem
- KNIHY
Hodnocené. / 5. Na základě hodnocení zákazníků
4-8 Section 4: Operation
Moseley SL9003Q 602-12016 Revision G
4.3.2 Saving Settings (system-wide)
Changes Made
SAVE SETTINGS?
NO
The "Save Settings" screen will appear after the user has made some kind of change
using either a configure or control screen.
If this screen appears, and the user did not intend to change anything, then select NO
(using the RIGHT/LEFT arrows) and press ENTER.
CAUTION:
This is a system-wide choice. If "YES" is selected, and ENTER is pressed,
any settings that were changed since the last save WILL BE SAVED to
power-on memory.
NOTE:
Most settings in the Configuration Screens will cause that setting to
change immediately. HOWEVER, if the user chooses "NO" (above), then a
power reset will bring the unit back to the previous settings.
4.3.3 Screen Menu Structure
Figures 4-4 shows the top level tree structure of the screen menu system. Go to the
indicated section for the selected LCD Screen Menu.
In general, <ENTER> will take you to the next screen from a menu choice, <UP> or
<DOWN> will scroll through screens within a menu choice, and <ESC> will take you
back up one menu level. Certain configuration screens have exceptions to this rule, and
are noted later in this section.
- Starlink SL9003Q 1
- WARRANTY 2
- Table of Contents 7
- List of Figures 9
- 1 System Features and 11
- Specifications 11
- 1.1 System Introduction 12
- 1.2 System Features 13
- 1.3 Specifications 14
- 1.4 Regulatory Notices 21
- FCC Part 15 Notice 21
- 2 Quick Start 23
- 2.1 Unpacking 24
- 2.2 Notices 24
- WARNING 25
- 2.3 Rack Mount 26
- SL9003Q 2 or 4 Channel 27
- Receiver 27
- Transmitter 27
- RX ANTENNA 28
- Digital Composite 29
- SL9003Q TX Main Menu 30
- Scroll Right/Left to choose: 31
- AUTO/OFF/ON 31
- 2.6.1. Audio 32
- 2.6.2. Composite 33
- 2.6.3. Data Channels 33
- 2.7 Performance 34
- Receiver Performance Check 36
- 3 Installation 37
- 3.1 Rear Panel Connections 38
- CAUTION 39
- 3.2 Preliminary Bench Tests 41
- SL9003Q 2 Channel 42
- 3.2.1. RF Bench Test 44
- 3.3 Site Installation 50
- 3.3.1. Facility Requirements 52
- 3.3.2. Power Requirements 52
- (Typical) 53
- 3.4.3. Environmental Seals 54
- 3.6 Link Alignment 55
- 4 Operation 57
- 4.2.1 LCD Display 59
- Changes Made 64
- SAVE SETTINGS? 64
- 7.4 Screen Menu Summaries 65
- 4.4.1 Meter 66
- 4.4.2 System: Card View 66
- 4.4.4 System: Info 67
- 4.4.6 Factory Calibration 69
- Caution 69
- Section 4: Operation 4-15 71
- Section 4: Operation 4-17 73
- 4.4.9 System: Transfer 74
- 4.4.8 System: Date/Time 74
- Section 4: Operation 4-19 75
- 4.4.11 Alarms/Faults 76
- Section 4: Operation 4-25 81
- 4.4.13 Radio TX Status 83
- 4.4.14 Radio RX Status 85
- 4.4.15 Radio TX Control 86
- 4.4.16 Radio RX Control 86
- Section 4: Operation 4-31 87
- Radio TX Config 88
- MHz950. 0000 88
- Radio RX Config 89
- 5 Module Configuration 91
- AUDIO ENC 92
- CAUTION: 93
- S21 – Data Channel 95
- S23 – System Config 96
- 5.2.1. AES/EBU and SPDIF 97
- 5.2.3. Data Channel Rate 98
- 5.2.4. Board ID 99
- 5.2.5. System Configuration 99
- 5.3.1. Data Channel 99
- 5.7 Power Amplifier 105
- 5.8 MUX Module 106
- 5.9.1. External I/O 108
- Received Signal Level (dBm) 115
- Vout (Vdc) 115
- 6 Customer Service 117
- 6.1 Introduction 118
- 6.2 Technical Consultation 118
- 6.3 Factory Service 119
- 6.4 Field Repair 120
- 7 System Description 123
- 7.5 Introduction 124
- 7.6 Transmitter 124
- 7.6.1. Audio Encoder 126
- 7.6.5. Power Amplifier 129
- 7.7 Receiver 130
- 7.7.1. Receiver Module 131
- 7.7.4. Audio Decoder 133
- 8 Appendices 135
- A.1. Introduction 137
- A.2. Path Analysis 141
- A.2.2 Losses 142
- B.1.1 Why dBm? 151
- B.1.2 Audio Meters 151
- B.1.3 Voltage-Based Systems 151
- B.1.4 Old Habits Die Hard 152
- Conversion (50 ohms) 155
- Modem Splitter 162
- Audio Processor 163
- (Optimod or Equiv.) 163
- Data Sharing Device 163
- Radio A - MAIN Default 164
- Radio B - STANDBY Default 164
- SL9003Q Receiver 164
- FCC ID: CSU9WKPCL6010 171
- MOSELEY ASSOCIATES, INC 171
- ASSEMBLED IN USA 171
- Remote Control 172
- Broadcast Tools 172
- SS 2.1 BNC III 172
- Switcher/Router 172
- INPUT: 90-260V, 47-63Hz 177
- F.7 Software Settings 181
- F.7.2 TP64 Settings 181
- For Hostile Environments 183
- INFORMATION - FCC Form 601 187
Související produkty a manuály pro Sítě Broadcast Tools SS 2.1/Terminal III
Sítě Broadcast Tools SS 4.1 III Uživatelský manuál
(140 stránky)
(140 stránky)
Sítě Broadcast Tools SS 4.1 III Specifikace
(11 stránky)
(11 stránky)
Sítě Broadcast Tools SS 4.1 III Specifikace
(17 stránky)
(17 stránky)
Sítě Broadcast Tools SS 2.1/Terminal III Specifikace
(16 stránky)
(16 stránky)
Sítě Broadcast Tools SS 4.1 III Specifikace
(13 stránky)
(13 stránky)
Sítě Broadcast Tools SS 2.1/Terminal III Specifikace
(42 stránky)
(42 stránky)
Epson R260 - Stylus Photo Color Inkjet Printer manuály
Uživatelské manuály a uživatelské příručky pro Tisk a skenování Epson R260 - Stylus Photo Color Inkjet Printer.
Poskytujeme 1 manuály pdf Epson R260 - Stylus Photo Color Inkjet Printer ke stažení zdarma podle typů dokumentů: Servisní příručka
Komentáře k této Příručce