Broadcast Tools DSC-20 Instalační manuál stáhnout pdf (Strana 31)

Preliminary 8-2002 RSHD Smartcaster Installation Manual

Final Notes...

If a station has a very "busy" Timed Events schedule, it is wise to write down the

schedule on paper before entering it into the computer. By planning ahead, fewer

mistakes are made.

Note: Build slowly! Try each event out once before entering all of them. For example,

try switching to news at the top of the hour at 1 PM before entering the other 23 hours.

The user may find that the news feed comes down 1 second earlier or later than expected.

Once the correct timing is discovered, then the user should add the events for the other

hours.

Current versions of software have added a method for mass scheduling, and for saving

lists of timed events. Consult the Software manual for these features.

Setting Audio Input/Output Levels on the RIDZ

Fig. 6.1. A close up of a connector and Phoenix plug

on the back panel of the RIDZ Switcher.

The RIDZ Switcher has trim pots for setting the input levels. They are located on either

side of the channel connector. They are 20 turn trim pots and will click when turned to

the end of either range. Turning the trim pots clock-wise increases the input gain on the

incoming signal. There are two other knobs on the front for controlling output levels for

both PRGM OUT and REC OUT. The input sources must be kept below +12db or

damage to the RIDZ may occur. It may also cause problems with the audio routed

through the switcher. Sources that are still too loud may need to be padded down by the

engineer. It is best for the inputs to the RIDZ to be around 0db. The levels are pre-set to

0db on the RIDZ before they are shipped. The maximum gain the RIDZ can give to a

low input signal is +25db.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 56 57

Žádné komentáře

Broadcast Tools DSC-20 Instalační manuál Strana 31